Could somebody get a Dana 60/14 bolt measurement?

[Advent]

On the rear axle, I'm wondering how far it is from the inner edge of the full floater spindle (basically where the tube ends and it's welded on) to the wheel mounting surface. If possible, I could use a dually measurement too. Dana 60 or 14 bolt, doesn't really matter.

AKA, if I were to weld the spindles onto a different axle, how much wider would it make each side?

Just cooking up an interesting idea...

[mousee]

Do you have access to tools to respline?

[Advent]

No, the idea involves "standard" 35 spline shafts.

[Advent]

Anyone? Please?

[AK20]

I can try to get you one off my 14 bolt tomorrow while I'm at Kevin's working on the motor, it's SW FYI...cant't help on the DW, maybe Highboy 76 could measure his?

[Advent]

Thanks man :)