Dana 300 info

[STOMPR]

Can I mount a Dana 300 to my AW4 auto tranny in my XJ ? Is there a stock configuration that would allow this? need to find the solution to making my XJ go Full Widths 8)

[akdsmer]

Novak makes adapters for this installation:

http://www.novak-adapt.com/catalog/kit_153_aw4.htm

Us suzuki guys don't know if it will be a good fit or not!

[STOMPR]

Your right I should do this
http://www.novak-adapt.com/catalog/kit_437amc.htm
and put a Turbo 350 or 400 in there with a 205 T case :!:

[akdsmer]

Perhaps, if you fancy something to bolt that new combo to......

http://i30.photobucket.com/albums/c332/looney-doone/bigblockphoto.jpg

[sevenslats]

I know you can mount it to the auto offered in TJs, whatever that is.

The d300 I swapped in to my TJ was 23-spline input. I think 6 holes in a circular pattern.
I believe Scout d300s used a Texas-shaped bolt pattern to mount to a tranny.

There's also 2 diffrent types of output shaft housings. I lucked out and found the long-output version, and it holds my speedo gear quite nicely.

[mousee]

yeah. the circular bolt pattern will work with it. should bolt right up. worst case scenario is you may need to redrill the tranny a little...

[crazy4ink]

I still have the adaptor ring that I bought (like Sevenslats) but didn't need it for my NV3550 tranny. I will sell it to you super cheap!!!